Configuring snmp string for Lightweight AP1242 AG from WLC

Answered Question

We have 1242 AG access points deployed for Wi-Fi access in LWAAP mode. After joining the APs on to the controller we try to configure the SNMP strings for the APs on the WLC but cannot find anywhere to do it.

Is snmp supported in the lightweight AP

if it is, then how I can configure it, via WLC or WCS?


Appreciate any feedback.


Correct Answer by bbxie about 8 years 5 months ago

LAP is different from Autonomous AP, it is stick to the WLC, so you can only configure SNMP for WLC, not for LAP. All the infor about the LAP can be obtained from WLC

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
bbxie Mon, 09/01/2008 - 18:05

LAP is different from Autonomous AP, it is stick to the WLC, so you can only configure SNMP for WLC, not for LAP. All the infor about the LAP can be obtained from WLC

ALAN HARKRADER Mon, 10/27/2008 - 15:05

Not without standing on your head (OID-wise)... can I configure a community on the LAP and have it stick once the WLC takes charge?

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode