cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
462
Views
0
Helpful
7
Replies

BRI - Outgoing call setup error

markotisler
Level 1
Level 1

Hi,

i am experiencing the following problem when establishing calls over BRI ports. There are 6 BRI ports configured as a trunk group and are configured like this:

BRI configuration:

isdn switch-type basic-net3

isdn overlap-receiving

isdn not-end-to-end 64

isdn incoming-voice voice

isdn outgoing-voice info-transfer-capability 3.1kHz-audio

isdn outgoing display-ie

The incoming calls are working fine, but outgoing calls fail. The call setup goes like this:

1. TX->SETUP

An then instead of RX->Call_Proc i get:

2. RELEASE_COMP pd = 8 callref = 0x8D Cause i = 0x82E404 - Invalid information element contents

Any ideas how could this be solved?

Regards,

Marko

7 Replies 7

Marwan ALshawi
VIP Alumni
VIP Alumni

do u have the network-clock-participate wic

configured?

Yes, for all three slots.

The soultion was to force TEI=0 towards provider.

shinepjoseph68
Level 1
Level 1

Hi Marko,

Wondering how did this issue was resolved? I am having exact issue.

Thanks

Shine

Have you read above ?

The soultion was to force TEI=0 towards provider.

Forcing TEI value to zero makes the BRI layer 2 comes up and multiple frames establishes, and eventually, the incoming calls worked. Dependning on your ISDN switch type, the outgoing call may or may not work with this setting. If you are connected to a-law compatible switches at the telco, susch as Basic-net3, then you must chnage the compand-type value on the voice-port to a-law. This was the fix in my case.

Thanks for the response.

You're welcome, please remember to rate useful posts with the scrollbox below.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: