PWR-C45-4200ACV -error disa but no alarm?

Unanswered Question
Sep 1st, 2008


I had several times the issue, that one PS of the C45-4200 type was in the following state:

PS2 PWR-C45-4200ACV AC 4200W err-disable good good

The problem is, that no SNMP trap was generated and so nothing was noticed unless someone used the show power command.

After reset the PS, a big bang occurs normally and then, of course, you have all the alarms you want...

Is this a design problem or how can one ensure PS redundancy?

Thanks and regards


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion