CatOS Error-Console

Unanswered Question
Sep 1st, 2008
User Badges:

Hi NetPro,


does anyone knwo this ?


Error-1-Console> sh test 1


Diagnostic mode: complete (mode at next reset: complete)

Diagnostic failure action for SUP: offline (mode at next reset: offline)



Module 1 : 2-port 1000BaseX Supervisor

Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Untested)

ROM: . Flash-EEPROM: . Ser-EEPROM: . NVRAM: . EOBC Comm: F


Line Card Firmware Status for Module 1 : PASS


Port Status :

Ports 1 2

-----------

. .


GBIC Status :

Ports 1 2

-----------

N N


Line Card Diag Status for Module 1 (. = Pass, F = Fail, N = N/A, U = Untested)


Module 1

Earl IV Status :

NewLearnTest: F

IndexLearnTest: F

DontForwardTest: U

DontLearnTest: U

ConditionalLearnTest: F

BadBpduTest: U

TrapTest: U

MatchTest: U

PortSpanTest: U

CaptureTest: U

ProtocolMatchTest: U

ChannelTest: U


Loopback Status [Reported by Module 1] :

Ports 1 2

-----------

F F



your reply will be highly appreciated.


regards,

Jack

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
JORGE RODRIGUEZ Mon, 09/01/2008 - 21:40
User Badges:
  • Green, 3000 points or more

Could you provide more info like "show module" "show system", this means hardware issues EOBC Comm: F see Table 5-106 in link bellow. Are there any other cards installed in the chasis preseting problems, I would suggest to open TAC case for this issue.



http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/command/reference/sh_ti_tr.html



PLS rate any helpful posy if it helps



Rgds

Jorge

Actions

This Discussion