09-02-2008 03:10 AM - edited 03-06-2019 01:07 AM
Hi! I need to know the uptime of a module installed in CAT6509 running IOS. Is there a command to view that?Thanks
09-02-2008 03:37 AM
I am not aware of actual command , but other way could be :)
"See the logs generated while module was removed & re-inserted if the logs shows timestamp, comapre the current switch time & log timestamp "
HTH..rate if helpful
09-02-2008 03:47 AM
thanks for the reply. I'l try to check on that.
09-02-2008 04:02 AM
Hi,
You can use this command:
show diagnostic events
After initial booting of the switch you should get an entry every time a module initialises.
HTH
Andrew.
09-02-2008 04:35 AM
Hi Andrew,
Thank you very much for your response. It helps a lot.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: