09-02-2008 12:37 PM
I have a Cisco PIX Firewall 535 Version 6.3(4) and we have been having problems with this firewall restarting. It is being managed by DFM 3.0.3. We have not received a single alert or email in regards to this device. We have been shutting down and powering on this device the last couple of hours and not one alert has came in. Could someone please advise as to what I need to do?
09-02-2008 02:31 PM
Provided the firewall is in a Known state in DFM, nothing additional needs to be done. DFM should be managing it. You may want to check your polling and threshold parameters to make sure the device is being managed as you desire.
09-03-2008 08:04 AM
Hi Thanks for the response.
The device is still stuck in a learning state....I applied the DFMInChargeSubscriber.class patch thinking that would resolve the problem, but it didn't.
These are the steps I followed:
1.- c:\net stop crmdmgtd
2.- Take a backup of your original file, and replace with the attached, you can find it under:
\CSCOpx\www\classpath\com\cisco\nm\vhm\inventorycollector
3.-Start CW again
Win: c:\net start crmdmgtd
I really hope by upgrading to LMS 3.1 next weekend really resolves this problem with DFM.
09-03-2008 08:33 AM
There is an official patch for this on Cisco.com at http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-dfm . The bug is CSCsi01966. This only fixes the bug where a device hangs in learning state at 40%, then goes to Questioned. Any other learning percentage would not be fixed by this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: