Switch interface capabilities through SNMP?

Unanswered Question
Sep 2nd, 2008

Below is an example of what one gets with the command "show interface capabilities module 4". My question is: Is there a way to get the same information using SNMP?

FastEthernet4/1

Model: WS-X4148-RJ-RJ-45

Type: 10/100BaseTX

Speed: 10,100,auto

Duplex: half,full,auto

Trunk encap. type: 802.1Q,ISL

Trunk mode: on,off,desirable,nonegotiate

Channel: yes

Broadcast suppression: percentage(0-100), sw

Flowcontrol: rx-(none),tx-(none)

VLAN Membership: static, dynamic

Fast Start: yes

Queuing: rx-(N/A), tx-(1p3q1t, Shaping)

CoS rewrite: yes

ToS rewrite: yes

Inline power: no

SPAN: source/destination

UDLD: yes

Link Debounce: no

Link Debounce Time: no

Port Security: yes

Dot1x: yes

Maximum MTU: 1552 bytes (Baby Giants)

Multiple Media Types: no

Diagnostic Monitoring: N/A

FastEthernet4/2

......

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion