cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
395
Views
0
Helpful
6
Replies

CM 6.1.1 Upgrade to CM 6.1.2 Network Connectivity Problems

acjarvis
Level 1
Level 1

After upgrading from CM 6.1.1 to CM 6.1.2 I'm having trouble keeping network connectivity to the server. During startup I see it start the ETH0 interface and I can ping the device. I have seen two different times the device stop responding to pings

1) At the normal login screen after bootup

2) At the screen in the screenshot attached the the message.

Any help would be greatly appreciated.

I have tried to login and do a switch version since I sometimes have brief connectivity till "something" stops it.

Thanks,

Aaron

6 Replies 6

Tommer Catlin
VIP Alumni
VIP Alumni

Check your eth0 connection speed/duplex setting on CUCM and the switchport. They should match.

They were previously set to auto/auto (sp/dup) and worked fine. I just tried moving to 1000/FULL and didn't change anything. I'm also not seeing any errors on the interface as well.

Thanks,

Aaron

Gigabit should be set to Auto|Auto

Which switch model and interface configuration?

Catalyst 3750 WS-C3750G-24TS-S1U

Interface config

description ccm01

switchport access vlan 678

switchport mode access

mls qos trust cos

no snmp trap link-status

no mdix auto

spanning-tree portfast

gogasca
Level 10
Level 10

Per image looks like an IBM server.

Which NIC is connected to, how many servers?

Which exact model?

Per image something happens when CLM is invoked.

After all services start|boot up complets connectivity fails or is restored?,

no icmp respose?

Please let us know

Thanks

NIC 1 is connected.

MCS-7825I1-IPC1

After I get to the login screen its only active for about a minute or so and then dies(no ICMP response).

Thanks,

Aaron

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: