09-04-2008 01:00 AM
Hi,
I currently have a PIX setup at SiteA and a 1720 router at SiteB. There is a LAN-to-LAN tunnel between the 2 sites. If I was to setup a second tunnel at SiteB terminating on the 1720 router, will it be possible to configure the tunnels so SiteA also has access to the customer VPN tunnel?
I would also want to have VPN tunnels that terminate at the PIX (SiteA) to also be accessible from SiteB.
Would it just be a case of configuring the crypto ACL's for the traffic?
Thanks
Solved! Go to Solution.
09-04-2008 01:04 AM
have a look at the following link will be very usefull
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807f9a89.shtml
good luck
if helpful Rate
09-04-2008 01:04 AM
have a look at the following link will be very usefull
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807f9a89.shtml
good luck
if helpful Rate
09-04-2008 02:31 AM
I think that helps. From my understanding of it, for the customer VPN tunnels that terminate on the 1720 and that need to be accessed from behind the PIX, I should only need to modify the crypto map acl's and the NAT0 acl's. The same interface traffic issue doesn't apply in this case. Is this correct?
09-04-2008 04:42 AM
correct, the 1720 won't have a problem with same interface traffic.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide