satish_zanjurne Thu, 09/04/2008 - 01:55
User Badges:
  • Silver, 250 points or more

can you attach the configuration ??


Hope you have configured essential the "ip nat inside" & "ip nat outside" under the correct interface ??


Also you must have configured the NAT pool if you are not doing overload ??


HTH..rate if helpful..



bh@rg@vdes@i Thu, 09/04/2008 - 20:59
User Badges:

Hi


It is better if you can give us the config

but general config is like this

Nat inside and outsied interface config

access list config

pool config

and nat statement


for furthure help go to


http://www.cisco.com/en/US/tech/tk648/tk361/tech_configuration_examples_list.html


http://www.cisco.com/en/US/products/hw/routers/ps2167/products_configuration_example09186a0080093fcf.shtml



HH


Bhargav

smohanasundaram Fri, 09/05/2008 - 03:08
User Badges:



Please go through the following configuration example.



Fastethernet 0/0

ip address 192.168.0.1 255.255.255.0


Fastethernet 0/1

ip address 10.0.0.1 255.255.225.0

ip nat inside



Serial 0/0/0

ip address 125.25.23.12 255.255.255.254

encapsulation ppp

ip nat ouside



ip nat inside source list 101 interface serial 0/0/0 overload


access-list 101 permit ip 10.0.0.0 0.255.255.255 any



HTH


Regards


S.Mohana sundaram

Actions

This Discussion