sccp plar phones not automatically dialing

Unanswered Question
Sep 4th, 2008
User Badges:

I have an issue when I pick up an analog phone, at first all I get is a dial tone but when I hang it up and pick it up again, then it dials. It is connected to a vg224 and I have the sccp plar dial XXXX commands in there. This really seems to happen more when the phone hasn't been picked up in a while. Anybody run into this issue? The version of IOS on the VG is 12.4(9)T6


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Thu, 09/04/2008 - 05:52
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

if u have this config with FXS port to an analog phon try to make the config like


under the fxs port do:


connection plar [number]


and have a look at the following link


http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a008009431b.shtml


good luck


if helpful rate

Actions

This Discussion