09-04-2008 05:57 AM - edited 03-15-2019 01:02 PM
I want to force a particular extension to use a specific FXO for billing.
I can't seem to find the documentation on this for CCME.
Thanks,
Andy
Solved! Go to Solution.
09-04-2008 06:14 AM
ok this can be done trhoguh COR list
lets say the port is 0/0/1
do the following
dial-peer cor custom
name fxo
name all
dial-peer cor list restrected
member fxo
dial-peer cor list not-restrected
member fxo
member all
dial-peer cor list fxo-only
member fxo
dial-peer cor list all-ports
member all
creat dialpeer going through that fxo
for example
dial-peer voice 9 pots
destination-pattren .T
Cor outgoing fxo-only
port 0/0/1
now lets say u have other ports u want other employees to use it
dial-peer voice 9 pots
destination-pattren .T
Cor outgoing all-ports
port 0/0/2
now apply the cor list in the incoming directionto the extention line
for example:
Ephone-dn 1
cor incoming restrected
Ephone-dn 2
cor incoming not-restrected
based on the config above the DN 1 will have access only to port 0/0/1 while DN 2 will have access to both !
if u want only DN have access to only that port just remove the member fxo from not-restrected
so the DN 1 will have access to port 0/0/1 and DN 2 will have access to port 0/0/2
good luck
if helpful Rate
09-04-2008 06:14 AM
ok this can be done trhoguh COR list
lets say the port is 0/0/1
do the following
dial-peer cor custom
name fxo
name all
dial-peer cor list restrected
member fxo
dial-peer cor list not-restrected
member fxo
member all
dial-peer cor list fxo-only
member fxo
dial-peer cor list all-ports
member all
creat dialpeer going through that fxo
for example
dial-peer voice 9 pots
destination-pattren .T
Cor outgoing fxo-only
port 0/0/1
now lets say u have other ports u want other employees to use it
dial-peer voice 9 pots
destination-pattren .T
Cor outgoing all-ports
port 0/0/2
now apply the cor list in the incoming directionto the extention line
for example:
Ephone-dn 1
cor incoming restrected
Ephone-dn 2
cor incoming not-restrected
based on the config above the DN 1 will have access only to port 0/0/1 while DN 2 will have access to both !
if u want only DN have access to only that port just remove the member fxo from not-restrected
so the DN 1 will have access to port 0/0/1 and DN 2 will have access to port 0/0/2
good luck
if helpful Rate
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: