Serial Interface Alarms

Unanswered Question
Giuseppe Larosa Thu, 09/04/2008 - 06:28
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Walter,

how are these serial interfaces connected?


how they are configured ?

Is one side configured for providing clock with clock rate command ?


Hope to help

Giuseppe


What are the serial interfaces currently plugged into? down/down state means the physical layer is down. If you would like to test out the interfaces & don't have a T1 to connect them to, you can either make a T1 loopback plug...Pin 1 goes to 4 & 2 goes to 5, or make a T1 crossover cable and connect one router to the other.

Actions

This Discussion