CALLMANAGER-QSIG-GF-ALCATEL-4400

patcbr600 · ‎09-04-2008

Hi all,

I'm having the folowing senario,

PSTN-->CISCO-GW-2821---->CALLMA-(QSIG-GF)----->ALCATEL-4400.

When same one from the pstn call to a DN on alcatel 4400 the alcatel 4400 responds to a setup from the callmanager with a CALL-PROC folowed by a ALERTING with PI=8 and folowed by a PROGRESS with a PI=8. With the alerting with PI=8 the pstn does not open the audio channel. The alcatel 4400 as a feature (connect on progress) that generate a connect message in the presence of a progress message. On the cisco does any one knows a equivalent feature on the cisco side to send the connect message to the pstn based on the receiving progress from the alcatel.

Many thanks

przemzambrzy · ‎03-12-2009

Hi all,

I have similar problem. Does anyone find a solution?

Thanks in advance

aherraez77 · ‎03-24-2009

Hello:

Have you tried to use this comand in the GW cisco?

In the pots outbound dial peer:

progress_ind progress enable 8

Hope this helps, please rate post if it does!

patcbr600 · ‎03-24-2009

Hi all,

The only way to resolve the issue was using

a a feature "connect on progress" on alcatel side.