MCU/EMP start setup over telnet

Unanswered Question
Sep 4th, 2008
User Badges:

once i have found a vxworks command to start the setup remotely, but i lost it.

does anyone know it? it is good start the setup remotely to change e.g. password or IP address for EMP

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
roturner Mon, 09/29/2008 - 14:27
User Badges:

Hello there, the command you are seeking is modifyTargetDevice and note it is case sensitive. From here you have access to the menu as if you had a console connection.


All the best Roger.



a.klessa Tue, 09/30/2008 - 05:38
User Badges:

hi,


thanks a lot, that is what i was looking for.


best

aleksander

Actions

This Discussion