cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
513
Views
0
Helpful
2
Replies

QSIG MGCP INTREGATION with MD110

earphoria
Level 1
Level 1

Hi everybody, i have done a qsig MGCP integration with an MD110.

Everything works fine, but my problem begins when other PBX that are integrated too with MD110 don't arrive my calls (an ALCATEL with a qsig trunk against the ericsson MD110).

I trace the qsig q931 of my voicegateway.

Can anybody help me about.

In the attachmen you can see a call originated in my CCM 6.1 and the destination called is an extension through this alcatel-PBX.

An puts me the next statement:

*Sep 5 11:05:41.159: ISDN Se0/0/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0

x8033

Cause i = 0x81E5 - Message not compatible with call state

The calls between the CCM 6.1 and the MD110 works right!!

Thanks in advance

2 Replies 2

slongewa
Level 1
Level 1

What version of the MD110 software are you running? What does the route data look like for the trunk going to the CCM and the Alcatel look like? (I believe the command is RODAP; if you are in command line mode on the Ericsson, but can't remember for sure.)

Thx,

Steve

tuann
Level 1
Level 1

Hi Earphoria,

Which version is the MD110 and did you get the name &n umber to pass from Ericsson to Cisco? If so, could you please send me docs. on how to set that up? Thanks...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: