MARS 20

Unanswered Question
Sep 5th, 2008
User Badges:

Hi Everyone,


recently installed MARS appliance. After a few days i was not able to connect to the device any longer. when I console onto the box i keep see pop up (like the boot sequence) that the loopback and network card is ok. but when i check the interface the config isn't there anymore. further more, i configure it and it reboots, but doesnt take the config.



has anyone seen this before? firmware is 4.3.1

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
smalkeric Thu, 09/11/2008 - 11:44
User Badges:
  • Silver, 250 points or more

The first time you boot the appliance and whenever you re-image it, you must configure the MARS Appliance.

Before you begin to configure the appliance, you can ensure whether the instructions given in the below URL has been completed.


http://www.cisco.com/en/US/docs/security/security_management/cs-mars/5.3/installation/guide/setup.html#wp1151176


Actions

This Discussion