09-08-2008 04:01 AM - edited 03-06-2019 01:14 AM
Hi,
Does anyone know someway to see in the router wich IP address is generating more traffic?
With nbar I can see wich protocol is loading the link but not the IP who is doing this.
I would like to know if I can do that with only the router cli, with no external server.
Thanks
Solved! Go to Solution.
09-08-2008 04:04 AM
Hi
you can make use of netflow to check the same.
you need to enable ip route-cache flow under the ethernet interface and can check the traffic pattern using show ip cache flow command.
The output will give u a clear idea about the source/destination port/ip address packet counts to identify the utilization pattern.
regds
09-08-2008 04:12 AM
Hi.
You can use Netflow for the ingress or IP accounting for checking egress
Netflow:
interface FastEthernet0/0
ip flow ingress
show ip cache flow
IP Accounting:
interface FastEthernet0/0
ip accounting
show ip accounting
09-08-2008 04:04 AM
Hi
you can make use of netflow to check the same.
you need to enable ip route-cache flow under the ethernet interface and can check the traffic pattern using show ip cache flow command.
The output will give u a clear idea about the source/destination port/ip address packet counts to identify the utilization pattern.
regds
09-08-2008 04:12 AM
Hi.
You can use Netflow for the ingress or IP accounting for checking egress
Netflow:
interface FastEthernet0/0
ip flow ingress
show ip cache flow
IP Accounting:
interface FastEthernet0/0
ip accounting
show ip accounting
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: