LMS 3.0(1) Common Service Unity Voice Messaging Server

Unanswered Question
Sep 8th, 2008


Im trying to add the Unity Voice Messaging Server in Common Service for the reason of viewing my cluster using Topology Service and possibly viewing the Service Attributes.

DCR has the Unity Server recorded. SNMP service is set on the services but when I run the data collection, it does not pick up.

Is this due to CDP and is there a way I can add other Microsoft servers such in Common Service?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Tue, 09/09/2008 - 15:18

You need to walk sysObjectID from Device Center > Tools > SNMP Walk. Use "sysObjectID" as your starting OID.

Peter Valdes Tue, 09/09/2008 - 15:32


Here is the result:

The following is a SNMP walk of device starting from sysObjectID

SNMP Walk Output



. = OID: .

Identical to the previous post.

Joe Clarke Tue, 09/09/2008 - 16:58

This device is not supported by Campus Manager. While it might show up in Topology, it will be managed as an unknown device. There is currently no plan for support of this device in Campus Manager.

Peter Valdes Tue, 09/09/2008 - 17:32

Hi jclarke,

This device is not even visible on the topology service. Could this be the reason?

I have another server visible on the topology but is not attached to a switch (probably due to CDP) on the diagram and also part of the unknown device (which you have already mentioned).

Thanks again

Joe Clarke Tue, 09/09/2008 - 18:59

If the device is not appearing on the map at all, it could be because it is filtered out from Campus Data Collection due to your Data Collection filter settings.

Peter Valdes Tue, 09/09/2008 - 19:28


Data Collection filter is clear. It does not have the IP Address to exclude and is currently set to enable auto mode.

I notice that on Campus Manager, Admin, Data Collection, Device Management, Include Devices when I click "show included devices" the server that is visible in topology service is there as manage (management state), but the Unity Server is Not Manage (due to what you have stated earlier) and is not visible in topology service.


This Discussion