Light weight Access Point problem

Unanswered Question
Sep 8th, 2008

Hi all,


I have wireless network with Wireless Lan Controller 2100 and Light Weight Access Point 1300.All thing run well.


But when we need some change on network, i changed IP of LAP 1300 to incorrect IP address. So it can not communicate with Wireless Lan Controller.


I try to config it by console but cannot becaused it had registered with WLC before.


Any one can help.

Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
nkariyawasam Tue, 09/09/2008 - 02:23

According to my experience you may have two ways to get out;


1. Try to log in to LAP using Cisco userid/password before it getting connected to WLC. Then clear it's private config using "clear private-config" command.


2. Irrespective of the configured IP of hte AP, if you plug the LAP to the AP-management VLAN of WLC it should get connected to WLC ( privided that Ap Management VLAN has a DHCP server) Then you can create override user ID on AP , log in to AP using the new user id instead of "Cisco", and then re-config hte AP IP.


NalakaK.

Scott Fella Tue, 09/09/2008 - 04:15

Here are some steps you need to do:


First, check the flash:

lap_1300#dir

Directory of flash:/


2 -rwx 279 May 09 2008 11:52:20 +00:00 env_vars

4 -rwx 6168 May 09 2008 11:52:20 +00:00 private-multiple-fs

6 drwx 256 May 09 2008 11:49:05 +00:00 c1300-k9w8-mx.124-3g.JA2

5 drwx 128 Mar 01 2002 00:03:43 +00:00 c1300-rcvk9w8-mx


15998976 bytes total (10716672 bytes free)



Then delete the LWAPP image:

lap_1131#delete /r /f flash:/c1300-k9w8-mx.124-3g.JA2


Not the one the has rcv in it!!!!!!



Thirdly reload the AP:

lap_1300#reload


Then issue a clear lwapp private-config


You'll end up with a clear AP.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode