09-08-2008 11:37 PM - edited 03-03-2019 11:27 PM
Hi ! really appreciate if somebody has this solution/ever encountered this problem:-
Wan conncations point to point
================================
I've one side cisco router with wic 2T serial card the others side is VWIC2-MFT-T1/EI ehich is second gen of e1/t1 card, i understand this card is not supporting (channel-group unframe) so i configured timeslot 1-31 to make full use of 2 mb line, but the line is refuse to up, i swapped with test router (witH wic2t) it's working fine which means the line is ok... any explainnation would be much appreciated...
Thanks
09-09-2008 01:56 AM
Hi!
For this card: VWIC2-MFT-T1/E1 did you specified to use T1?
Or better can you paste here your configs from both sides?
Thanks!
Cheers,
Calin
09-09-2008 09:25 PM
Hi Calin, I think I solved the problem, it's due to the setting at the NT, this card support structed but the modem at the remote side is setting unstrusted, once change to structed the line up immediately...
Thanks man..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: