Need telnet access without NAT

vijaykumargowda · ‎09-09-2008

I have an issue with ASA 5510 Firewall.I have three interfaces X,Y and Z, where X has a security level of 0, Y=0 and Z=10.

I need to access hosts on Y from Z.As of now it works fine with NAT.All i want is to access hosts with no NATing.

I have applied an access list to permit telnet and able to see the hit counts

,but i see only a black screen.I tried changing the security levels and applying same-security-interface command,but didnt work.

Is there anything else which you would like to tell us on this issue.

Any help would be appreciated.

Regards,

Vijay

andrew.prince · ‎09-09-2008

Vijay,

Try adding the following to your nat config:-

static (Z,Y) z.z.z.z y.y.y.y netmask x.x.x.x

or you could create a policy based no-nat....but try the above first.

HTH>

vijaykumargowda · ‎09-10-2008

Hello Andrew

The issue was with Internal routing.I added a route and it started working fine.

Thanks for your reply.

Regards,

vijay

andrew.prince · ‎09-10-2008

np - glad to help.