cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
631
Views
0
Helpful
3
Replies

Need telnet access without NAT

vijaykumargowda
Level 1
Level 1

I have an issue with ASA 5510 Firewall.I have three interfaces X,Y and Z, where X has a security level of 0, Y=0 and Z=10.

I need to access hosts on Y from Z.As of now it works fine with NAT.All i want is to access hosts with no NATing.

I have applied an access list to permit telnet and able to see the hit counts

,but i see only a black screen.I tried changing the security levels and applying same-security-interface command,but didnt work.

Is there anything else which you would like to tell us on this issue.

Any help would be appreciated.

Regards,

Vijay

3 Replies 3

andrew.prince
Level 10
Level 10

Vijay,

Try adding the following to your nat config:-

static (Z,Y) z.z.z.z y.y.y.y netmask x.x.x.x

or you could create a policy based no-nat....but try the above first.

HTH>

Hello Andrew

The issue was with Internal routing.I added a route and it started working fine.

Thanks for your reply.

Regards,

vijay

np - glad to help.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: