amarmn1975 Thu, 09/11/2008 - 02:16

HII,,

PLZ I want to configure TANDBERG 1700 MXP with CCM 4.2 is it possible.

Please HELP!!

Thanks

egrinkin1 Thu, 09/11/2008 - 09:35

Here is a related post. You might have some luck finding help searching the forum if no one has replied in a few days.

Posted by: ssparkes - Consultant, Omnetica Ltd - Sep 3, 2008, 8:24am PST

Hi, I have a CCM4.2(3)SR2b installation with several Tandberg (H323) and VTA (2.1) endpoints.

VTA to VTA is fine negotiating an H264 codec. Unfortunately the best I can get with the Tanndberg H323 endpoints is H263. I know CCM 4.1.3 introduced H264 support for SCCP endpoints. Does anyone know if there is supposed to be H264 support for H323 endpoints. The Tandberg endpoints are created within CCM as H323 devices. The tandberg endpoints have the IP address of the CallManager server for H225/245, ie they do not use a gatekkeper.

Thanks

I'm having no luck getting H264 working between

| Show All Messages | Subscribe | E-Mail this Message

Conversation Rating: 5.0 (1 vote)

unfortunately the support for h264 ... by javalenc - Sep 5, 2008, 2:55pm PST

Posted by: javalenc - PDI Escalation Engineer, CISCO SYSTEMS - Sep 5, 2008, 2:55pm PST

unfortunately the support for h264 is limited to sccp to sccp calls, there is no support for it with h323

Take a look at the system guide for 4.2(3) here:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a008070e4ea.html

In the Video Codec section, you see:

"The system supports H.264 for calls that use skinny Client Control Protocol (SCCP) on originating and terminating endpoints only."

HTH

java

if this helps, please rate

Actions

This Discussion