09-10-2008 06:04 AM - edited 03-06-2019 01:17 AM
My name is David,
Please I cant configure 2 TenGigabitethernet on Catalyst 4503, when I do that dont work the etherchannel I'm using interface Port-channel1, switchport on (global) and in the interfaces 10Giga the command .. switchport mode trunk and channel-group 1 mode on..... but the etherchannel dont work....please help me...thanks
09-10-2008 06:25 AM
Hi David,
1.What are the ports( Ethernet/Fastethernet/Gigabit/TenGigabit) on peer side ?
2.interface TenGigabitethernet
swicthport
switchport mode trunk
channel-group 1 mode on
this should work.
3.hope you are doing same config on peer side ??
4.Also if possible paste the config of all 10gig interface 2 on one side & 2 on another side , as well as confgi of port-channel interface ??
HTH..rate if helpful..
09-10-2008 02:02 PM
Thanks for all.... I have 2 Switch Catalyst 4503 that has every one 2 modules of 10 Giga... and i need configure etherchannel over that 2 modules of 10 Gigas....I use the commands taht you send me..but you forget the command global "interface Port-channel1" ??.. or it is confiigure by default ??...please help me..thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: