How to edit calling party number while on call forward?

Unanswered Question
Sep 10th, 2008

Hi Guys,

We have a little problem with our Callmanager 4.1.3

When we activate call forward on IP-Phones to our Mobile Phones we get the calling party number with a leading "0".

On the CCM-environment it is usefull because we use "0" to ring out into PSTN.

But when we forward a call to our mobile phones this leading "0" is not needed and the phone number must be edited before it can be dialed on mobile devices.

Is there a possibility to edit the calling party number when the call is forwarded ?

greetings Christian

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Jaime Valencia Wed, 09/10/2008 - 07:12

yes, configure a CSS for CF that reaches a translation pattern that strips the 0 before sending the call. just be aware you will need another route pattern without the 0 to route the calls to the outside, or create a separate route pattern and strip the 0 there. your choice as either would work



if this helps, please rate

christianluven Wed, 09/10/2008 - 10:33

Thanks for your reply, I will try it out tomorrow.

Maybe a have to take a look at the gateway if this does any number manipulation.....


This Discussion