×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Intercluster trunk between CM4 and CM6

Unanswered Question
Sep 10th, 2008
User Badges:

Is it possible to have an intercluster trunk between a CM4 and CM6. I have configured one but for some unknown reason whenever I phone a number destined for the other CallManager I get a fast busy about 5 secs. Any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marwan ALshawi Wed, 09/10/2008 - 07:31
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, December 2015

it is possiable !


have you checked that the aproparate CSS and partions configured on the ICT, route pattrens


also do u habe regions, locations might make problems but not with ip phone to ip phone, unless there is bandwidth limitations thats why u need to make sure its ok


good luck


if helpful Rate

Actions

This Discussion