Ok, all traffic need to go from vlan1 (192.168.4.0/24) to fe1 (dhcp) execpt any destination of 192.168.1.0/24 on fe0
if 192.168.1.0 destination go to fe0 from vlan1
if anything else need to go to fe1 from vlan1
I can not get anything to go out of fe0
router is 1811 attached is config
Thanks for the information and for running the test that I suggested. Especially since the router can ping devices connected on FastEther0 with a standard ping it establishes that there is connectivity and that IP addressing is ok. When the router can not ping the device when it specifies a source address different from FastEther0 then it suggests that the problem is that the device does not have the correct default gateway configured. Since the address on the router interface is 192.168.1.215, that should be the default gateway on the devices connected on FastEther0. If you check I believe that you will find that they are configured with some other default gateway. And if you configure them to use 192.168.1.215 as their default gateway then I believe that VLAN 1 will be able to ping them.