09-11-2008 08:57 PM - edited 03-09-2019 09:27 PM
Greeting
how can I add a user to use ASDM with readonly access on certain contents?
Any comments will be appreciated
Thanks in advance
09-12-2008 06:07 AM
Hi Julie,
To add a user and give htem read-only access to ASDM, you simply need to create a new user with a privilege level of 5. On the CLI, it will look something like this:
username cisco password cisco123 privilege 5
Here is the config guide for doing this through ASDM as well:
http://www.cisco.com/en/US/docs/security/asa/asa80/asdm60/user/guide/aaasetup.html#wp1284477
Also, if the command has already not been enabled, you will need to tell ASDM to authenticate users against the local user database:
aaa authentication http console LOCAL
Hope that helps.
-Mike
10-12-2008 06:53 PM
still have problem.
I have multi-contents, and the read only user can only see on context, not others? how can I make the readonly user to see all the contexts but no configure them?
Thanks
09-12-2008 06:28 AM
Just make sure you also have :
privilege level 5 mode configure command asdm
command in the config.
Please rate if helps.
Regards,
Sushil
09-18-2008 10:56 PM
Thanks for both replys.
regards "privilege level 5 mode configure command asdm", please advice:
if user0 have privilege 2 (default), and user1 has privilege 5, so user1 should be readonly user, what about user0? does user0 still can use asdm to change configuration on ASA5520?
Please advice
10-12-2008 08:03 PM
still have problem.
I have multi-contents, and the read only user can only see on context, not others? how can I make the readonly user to see all the contexts but no configure them?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: