wan link call control

Answered Question
Sep 12th, 2008

Can anyone tell me how I can control the number of calls going across a wan link. I am aware you can use locations in CCM. This scenario however is different. 1 site is ccm and the other is a PBX. They are connected via 2 routers using QSIG. I was hoping there was something you can do on the routers

I have this problem too.
0 votes
Correct Answer by Marwan ALshawi about 8 years 3 months ago

simply on the outgoing dial peer add the foolowing cammnad

dial-peer voice 9 voip

max-conn [max number of calls]

for wxample if u want to limit the number of calls to 9

do the following on the outbound voip dialpeer going to the other one

dial-peer voice 1 voip

max-conn 9

! 9 calls allowed on VoIP Dial Peer to Remote Site

good luck

if helpful Rate

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Marwan ALshawi Sat, 09/13/2008 - 00:43

simply on the outgoing dial peer add the foolowing cammnad

dial-peer voice 9 voip

max-conn [max number of calls]

for wxample if u want to limit the number of calls to 9

do the following on the outbound voip dialpeer going to the other one

dial-peer voice 1 voip

max-conn 9

! 9 calls allowed on VoIP Dial Peer to Remote Site

good luck

if helpful Rate

Actions

This Discussion