Router 2811 / when restart lose the configuration

Answered Question
Sep 13th, 2008
User Badges:

I apply the configuration in the router, save, copy run to star, review the config and all work ok, but when restart the router lose the configuration and ask if I want enter the initial configuration.


Correct Answer by Mark Yeates about 8 years 8 months ago

Walter,


This is more than likely from a previous password recovery. Your configuration register was probably not set back to the correct setting afterwords. Check out the link below to fix the configuration register.


0x2102 is the setting that you want.


http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml


HTH,

Mark

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Mark Yeates Sat, 09/13/2008 - 16:11
User Badges:
  • Gold, 750 points or more

Walter,


This is more than likely from a previous password recovery. Your configuration register was probably not set back to the correct setting afterwords. Check out the link below to fix the configuration register.


0x2102 is the setting that you want.


http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml


HTH,

Mark

Actions

This Discussion