09-13-2008 08:36 AM - edited 03-06-2019 01:21 AM
I apply the configuration in the router, save, copy run to star, review the config and all work ok, but when restart the router lose the configuration and ask if I want enter the initial configuration.
Solved! Go to Solution.
09-13-2008 04:11 PM
Walter,
This is more than likely from a previous password recovery. Your configuration register was probably not set back to the correct setting afterwords. Check out the link below to fix the configuration register.
0x2102 is the setting that you want.
http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml
HTH,
Mark
09-13-2008 04:11 PM
Walter,
This is more than likely from a previous password recovery. Your configuration register was probably not set back to the correct setting afterwords. Check out the link below to fix the configuration register.
0x2102 is the setting that you want.
http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a65a5.shtml
HTH,
Mark
09-14-2008 09:45 AM
Thanks Mark, my issue is solved
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: