Sub-interface routing

Unanswered Question
Sep 14th, 2008

Will a 2811 running 12.4(11)X/Advanced-Enterprise-Services route between sub interfaces?

I can't get traffic from f0/0.50 to route to f0/0.100. Both interfaces have IPs and are doing dot1q trunking.

Traffic from both these interface can route to f0/1.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
glen.grant Sun, 09/14/2008 - 02:08

Can you post the interface config , probably something with that . It should route fine between subinterfaces , probably the trunk isn't setup correctly between the router and switch. If possible post the switch config also.


This Discussion