Meetingplace DMZ Internet access

Answered Question

I setup a Meetingplace 6.0 system in a SMA-2 Web configuration. Used FQDN in the Web server setup for the internal and dmz server. When you send a link to a person, they can click on the link and get into the home page. When they press the browser test link it is the ip address of the DMZ server secondary link, not the FQDN. The Internal server works with the FQDN. What am I doing wrong. Everything else works!

Correct Answer by didyap about 8 years 8 months ago

To work around this problem, manually add the *.wsdl mapping back to the Application Settings of the web site.

This document provides the solution for when after you install Cisco Meeting Place Web 4.3.0.246.x DMZ-C, the Web Admin is unable to add the DMZ web server to the Site page


http://www.cisco.com/en/US/products/sw/ps5664/ps5669/products_tech_note09186a008039ef6c.shtml

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
didyap Fri, 09/19/2008 - 13:16
User Badges:
  • Silver, 250 points or more

To work around this problem, manually add the *.wsdl mapping back to the Application Settings of the web site.

This document provides the solution for when after you install Cisco Meeting Place Web 4.3.0.246.x DMZ-C, the Web Admin is unable to add the DMZ web server to the Site page


http://www.cisco.com/en/US/products/sw/ps5664/ps5669/products_tech_note09186a008039ef6c.shtml

Actions

This Discussion