SSL VPN Client (Full Tunnel) - can't access internal network

Unanswered Question
Sep 14th, 2008

I have managed to get working on my 877w Client-less and Thin Client SSL VPN modes but having trouble with the full tunnel setup. Externally I can launch the Anywhere client from the portal page (Tunnel Connection Start button). It connects and I get an IP address but I can't see any of the internal resources on the network (e.g. I can't ping/access the router or any of the other servers). Since this is my first Cisco router and I'm not very experienced with networking I would appreciate help on my configuration (attached).



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion