09-15-2008 06:50 AM - edited 07-03-2021 04:28 PM
When I try to make a change to an AP like the AP name or any other change the change does not take when I hit the apply button. WCS then dumps me to a blank controller page.
Anyone else seeing this?
09-15-2008 07:51 PM
Are you trying to create and apply a template? What version of code is running on the WLC?
09-16-2008 03:52 AM
WLC is running 5.1.151.0. When I log on to the WLC directly the changes are allowed and the WCS gets updated that the change has been made. It only seems when I make the change via the WCS that it fails.
09-16-2008 03:57 AM
One of my peers also had issues on that code, but with creating interfaces on the WLC. Were you trying to create a template and push that out?
09-16-2008 04:01 AM
Currently it is just working with the AP's. I added a few AP's and I was just trying to rename them to a more common name. It also seems to be any other AP changes. I have not tried anything else because I don't want to make too many changes while I have this problem.
10-07-2008 02:32 AM
i am alos haveing the same problem and have a similar setup, has anyone found a workaround yet?
10-07-2008 04:02 AM
The resolution ended up being a config sync problem between the WCS and Controller.
Sync the controllers at Configure > Controllers > check the box to select them all > and choose "Refresh Config From Controllers" from the dropdown list; when the next question comes up, choose to Delete conflicting information from WCS and believe the new facts coming in from the controllers.
This is what solved my problem.
10-07-2008 05:15 AM
Perfect sorted it out fine, had to do a few tweaks as i didn't have the local AP password template added since the upgrade, but added that and all good.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide