How do you factory default the MSE 3350 Mobility Solution Engine

Unanswered Question
Sep 15th, 2008

Hi Guys

I was wondering if anyone knows how to factory default the MSE or know of a way to enable the setup wizard again.

Is there a way to check the status or change the WCS communication password manually.

Thanks in advanced

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bbxie Mon, 09/15/2008 - 15:13

You can use following steps to restore factory default fo MSE:

Step 1 In Cisco WCS, click Mobility > Mobility Service Engines.

Step 2 Click the name of the mobility services engine you want to configure.

Step 3 Click System (left panel).

Step 4 Click Advanced Parameters.

Step 5 In the Advanced Commands section (right), click Clear Configuration.

Step 6Click OK to clear the mobility services engine configurations.

Scott Fella Mon, 09/15/2008 - 17:54

You can also run this from the cli to get the startup wizard:



This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode