LWAPP to Autonomous 1242AG AP

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
jaichauh Mon, 09/15/2008 - 10:20


Hardware is same. You can convert LAP by upgrading an autonomous image on it.

After convesrion, your LAP would work normally like an autonomous. But, if you ask for a replacement in future (due to any h/w issue on AP), you will get the LAP as a replacement from Cisco, as upgrade would not change the model number.

Please see the folloiwng link to change your LWAP to autonomous mode:




jaichauh Mon, 09/15/2008 - 10:50


You need to have a valid CCO login in order to download any image from Cisco:

Go to Support-->Download software-->Wireless Software-->Access points--->124o series--->IOS software--->download an IOS image.



amowat Wed, 09/17/2008 - 14:29

I have a valid CCO account (can post on the Forums without one), but cannot download the current 1240 IOS software. It just blankly sends me back to the IOS page. Frustrating.


This Discussion