HWIC-1FE as trunk

Unanswered Question
Sep 17th, 2008

I am not able to configure HWIC-1FE as a trunk port.However the switchport command is not available in its interface configuration mode.

any suggestions?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Calin Chiorean Wed, 09/17/2008 - 01:02

Hello!

HWIC-1FE is a router interface.In which device are you using it? You cannot configure a L3 port with swichport command.

Use subinterface on that module with "encapsulation dot1q 'vlan_number'" where the vlan_number is configured on the switch (if you connect the router to a switch) and allowed by the trunk config.

Please tell me if you understand or give more details.

Good luck!

Calin

Actions

This Discussion