Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
483
Views
0
Helpful
2
Replies

HUM doesn't display Top-N Interface Utilization

ROMAN TOMASEK
Level 1
Level 1

‎09-18-2008 02:12 AM

I installed HUM and I configured Poller for 4 devices to monitor interface utilization. I'm sending you the poller configuration. First HUM displayed all statistics correctly, but for now only one interface is seen in the quick report and no interface is seen in the Top-N Interface Utilization. Do anybody knows where is a problem? Thank you.

Labels:
Preview file
46 KB
Preview file
77 KB
Preview file
138 KB
0 Helpful
2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

‎09-18-2008 05:51 AM

The last time I saw this, there was a problem with the poller, and no new data was being collected. The solution was to remove and re-define the poller in question.

0 Helpful

ROMAN TOMASEK
Level 1
Level 1
In response to Joe Clarke

‎09-18-2008 06:14 AM

OK. I will try it:-)

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents