Loading new MIBs on a 1310 AP

Unanswered Question
Sep 19th, 2008

Hey everyone. I'm trying to diagnose a remote AP installation using SNMP. The default SNMP traps aren't adequate for what I need to monitor. For instance, with the built-in MIBs I can information like input/output errors, link status, etc.

But, what I really want is to monitor radio associations, RSSI values, interference values, and negotiated link speeds.

I went to Cisco's MIB locator and downloaded a few .my files (such as CISCO-DOT11-RADIO-DIAGNOSTIC-MIB.my) which seemed like they might help.

However, I am now completely stuck as to how to use these files. Anyone able to point me in the right direction?

Thanks a lot!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
tstanik Thu, 09/25/2008 - 11:18

For the SNMP to enable traps and poll the AP, make sure that the AP have the iso

view configured. Example:

snmp-server view iso iso included

snmp-server community view iso RO

snmp-server community view iso RW

To enable traps:

AP(config)#snmp-server enable traps ?

I hope it may help you.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode