On an ASA, I can do the following:
static (inside,isp1) 10.10.1.10 192.168.8.10 netmask 255.255.255.255
static (inside,isp2) 10.11.1.10 192.168.8.10 netmask 255.255.255.255
This allows the ASA to respond to traffic on either public interface, on behalf of the private interface, albeit with a return path specified by the routing table.
How can I do the same thing on a 2811 router?
If I try to enter two NAT statements using different public IPs, but the same private IP, the 2nd one overwrites the 1st.
Any help would be most appreciated.