09-22-2008 10:02 AM - edited 03-06-2019 01:30 AM
Can I setup a server with to load balance across the two switches that are in a stack? I've heard that you would need - multichassie etherchannel and this is only supported on the 6500 series? Thank you.
Solved! Go to Solution.
09-23-2008 08:05 AM
You'er welcome and please if you find my post helpfull please rate.
Thanks,
09-22-2008 01:31 PM
You can do that but you need to make sure that the IOS supports it. Etherchanneling is supported across multiple 3750 Switches in the same stack.
Hope this helps,
Appreciate your rating,
Regards,
09-22-2008 02:36 PM
Do you happen to know what IOS I would need? Thank you.
09-22-2008 02:43 PM
The feature you are looking for is cross-stack Etherchannel. You will need IOS of 12.2(25)SEC or higher. Below is the link:
Let me know if you need anything else,
Regards,
09-22-2008 02:55 PM
Thank you, appreciate it!
09-23-2008 08:05 AM
You'er welcome and please if you find my post helpfull please rate.
Thanks,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: