Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
405
Views
0
Helpful
3
Replies

crossover - straight through cable question

peter-net
Level 1
Level 1

‎09-23-2008 12:36 AM - edited ‎03-06-2019 01:31 AM

can someone tell me the command syntax to allow a switch port to "auto sense" or electronically re-orientate pin outs between a crossover and a straight through cable? Thanks, peter@it-123.co.uk

Labels:
0 Helpful
3 Replies 3

shastymacnasty
Level 1
Level 1

‎09-23-2008 12:47 AM

"The Auto-MDIX feature is enabled by default on switches running Cisco IOS

Release 12.2(1SE or later. For releases between Cisco IOS Release 12.1

(14)EA1 and 12.2(1SE, the Auto-MDIX feature is disabled by default. For

configuration information for this feature, refer to the switch software

configuration guide or the switch command reference"

I copied and pasted this from a posting from another site! HTH

0 Helpful

glen.grant
VIP Alumni
VIP Alumni
In response to shastymacnasty

‎09-23-2008 03:35 AM

This is only available on the newer switches and routers , the older stuff like 2950,3550's do not support this.

0 Helpful

peter-net
Level 1
Level 1
In response to glen.grant

‎09-23-2008 05:45 AM

thanks for this

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card