09-23-2008 04:22 AM - edited 03-15-2019 01:29 PM
I hope someone can help me with this one... A few days ago we received a new 7937G. I installed the required s/w on CM, restarted the CM tftp-server, connected the 7937G to a POE port and.. it worked. That is, when calling/being called from an IP-phone. When calling/being called from an analogue phone the 7937G makes loud "squeeky" noises, even before the analogue phone aswers the call. The voice-signal is severely distorted.
Applicable s/w:
Callmanager 5.1.3.3000-5
cmterm-7937-sccp.1-2-1.cop
cmterm-devicepack5.1.3.2104-1.cop
The 7937-sccp.1-2-1 flash is also loaded in the 7937G.
Given the fact that the problems arise only when calling or being called from an analogue phone: is there something that needs to be done in our voicegateway?
09-23-2008 04:48 AM
And from IP-phone to analog and vice verse works? Because 7937 is a SCCP device like all IP phones (if you don't use SIP)
JH
09-23-2008 05:12 AM
Hi JH,
That's right, all our other IP-phones (7911,7941 etc) can talk to analogue (and v.v) without a problem.
The 7937G (in SCCP mode) can communicate perfectly with an IP-phone, but communication with an analogue phone doesn't work.
06-30-2009 12:32 AM
I'm experiencing the exact same issus.
Local calls goes just fine, but whenever i issue a call with a phone on the PSTN through the voice gateway, the voice quality drops dramatically. You can see an excessive amount of packet loss, when looking at the phone status.
This is the only phone in the orginazation with this problem. It has even been switched with a phone that worked perfectly on another clients network, and the problem was not solved by a Callmanger upgrade either (they now run 6.1.3).
My guess is either the switchport or the voice gateway.
Any one?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide