Metro ethernet support

Unanswered Question
Sep 23rd, 2008

Hi all,

I have the folowing scenario:

Two 7604 conected back-to-back with a WS-X6148-GE-TX module. the vfi show up the ldp neigbhor show up but the on the vc detail i have :

Destination address:, VC ID: 100, VC status: up

Output interface: none, imposed label stack {21}

Preferred path: not configured

Default path: active

Next hop: Invalid ADDR

Also the show mpls forwarding :

N-PE1#show mpls forwarding-table

Local Outgoing Prefix Bytes Label Outgoing Next Hop

Label Label or VC or Tunnel Id Switched interface

19 No Label l2ckt(100) 0 none point2point

21 Pop Label 0 Gi4/2

Thus this configuration is supported on this module or is there samething else with the configuration ?

Many thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion