Hi all,
I have the folowing scenario:
Two 7604 conected back-to-back with a WS-X6148-GE-TX module. the vfi show up the ldp neigbhor show up but the on the vc detail i have :
Destination address: 2.2.2.2, VC ID: 100, VC status: up
Output interface: none, imposed label stack {21}
Preferred path: not configured
Default path: active
Next hop: Invalid ADDR
Also the show mpls forwarding :
N-PE1#show mpls forwarding-table
Local Outgoing Prefix Bytes Label Outgoing Next Hop
Label Label or VC or Tunnel Id Switched interface
19 No Label l2ckt(100) 0 none point2point
21 Pop Label 2.2.2.2/32 0 Gi4/2 10.10.10.2
Thus this configuration is supported on this module or is there samething else with the configuration ?
Many thanks