Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
497
Views
3
Helpful
2
Replies

Secure Addresses on Interface Cisco 800 series

Mehdi Talei
Level 1
Level 1

‎09-23-2008 09:51 AM - edited ‎03-06-2019 01:32 AM

Hello,

I am wondering if there is an equivalent command of mac-address-table secure for Cisco 800 series.

The point is that I would like to connect some specific machines (with specific MAC address obviously) to an interface of my router. I would like also to put the maximum secure addresses (Not sure if it is possible as there is in Catalyst)

You help is most appreciated.

Mehdi

Labels:
0 Helpful
2 Replies 2

Richard Burts
Hall of Fame
Hall of Fame

‎09-23-2008 10:36 AM

Mehdi

These restrictions are supported on the switches but not on IOS routers. So it is not possible to do these on the 800 series routers.

HTH

Rick

HTH

Rick

Mehdi Talei
Level 1
Level 1
In response to Richard Burts

‎09-23-2008 12:42 PM

Thanks for your help Rick.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card