09-23-2008 09:53 AM - edited 03-15-2019 01:29 PM
I have a site in London that has Cisco VOIP running off a 2811. We have a VPN tunnel up and running. I have a 2811 that some else started to config. Is there a link that would show me how to configure the other 2811 correctly. This going to be a test. Any help would be appreciated.
09-29-2008 01:13 PM
It will work but It's not recommended with 2811. Although VPNs guarantee a secure pipe end-to-end, they don't guarantee latency and variations in latency (Jitter). Therefore, the voice quality will likely suffer, depending on traffic conditions on the 'net.
09-29-2008 09:16 PM
hi Spencer
i can see from the files u have attached that u have a CME and u may look to let users in a remote site to rigister with that cme
based on ur requiremnt u will need basicly normal VPN between those router
but u need to conisder the ports that involved in the VOIP,and IP telephony to let t he phones rigister and voip flow over vpn
the following link is a case similer to yours but it include a firewall setup
igonre the firewall but consider the ideas like ip source and destination and PORTS :
good luck
if helpful Rate
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: