cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
416
Views
0
Helpful
3
Replies

Policing bandwidth

itdsmartnet
Level 1
Level 1

hi, i have configured QOS on my router, the following is the configuration.

class-map match-any HTTP_TRAFFIC

match protocol http

class-map match-any ftp-traffic

match protocol ftp

class-map match-any nbar-discovery

match protocol fasttrack

match protocol bittorrent

match protocol edonkey

match protocol gnutella

match protocol winmx

match protocol napster

class-map match-any STREAMING

match protocol h323

!

!

policy-map blocking_P2P

class nbar-discovery

police cir percent 1

conform-action transmit

exceed-action drop

class STREAMING

drop

class HTTP_TRAFFIC

police cir percent 50

class ftp-traffic

police cir percent 25

and then apply policy-map to the interface. My Question is that What bandwidth the class "class-map match-any nbar-discovery" will get. i have configured interface with bandwidth 4096. will all my protocol in class "class-map match-any nbar-discovery" share the 40500bps bandwidth or each protocol will get 40500 bps bandwidth.

Thanks

2 Accepted Solutions

Accepted Solutions

Marwan ALshawi
VIP Alumni
VIP Alumni

the whole class will get the assigned bandwidth

good luck

if helpful rate

View solution in original post

the 40500 bps will be shared by all protocol in the class. They will not get 40500 each.

View solution in original post

3 Replies 3

Marwan ALshawi
VIP Alumni
VIP Alumni

the whole class will get the assigned bandwidth

good luck

if helpful rate

Thanks for your reply i have confusion, the whole class will get 40500bps bandwidth or each protocol will get 40500bps.

the 40500 bps will be shared by all protocol in the class. They will not get 40500 each.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card